In Reply to: RE: Magnet wire gauge combo question posted by dcuhl on February 21, 2015 at 04:12:25:
Ok, I am sure you'll figure it out. Now, depending on how long and how many wires are used, you may want to have a few cheap combs to keep the wires spaced as you lay them down. I spaced them in the air with combs at each end, then stuck the first tape from the bottom. You probably don't need 10ft worth of each, like I did.
After peeling the magwire ends (light sanding paper works), soldering them together works best. Any decent banana plug will do if the solder is proper.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Magnet wire gauge combo question - JBen 08:45:10 02/21/15 (1)
- RE: Magnet wire gauge - dcuhl 10:29:28 02/21/15 (0)