|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
|
|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
In Reply to: RE: Adding series resistor for ribbon? posted by AkuAnkka on February 17, 2015 at 09:45:30:
It is a risk to have different type amps as far as coherence is concerned. Some people are more sensitive to it than others. When running the midrange without a low pass, the tweeter can be set to 10-12 khz XO and there is little room for coherence issues as there is broad overlap at the top octave.
If you run 1st order with the likely 5-6khz XO then overlap is again going to "save" you from the coherence problem unless you are particularly sensitive to it.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Adding series resistor for ribbon? - Satie 13:31:55 02/17/15 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
