In Reply to: RE: Well, Norman ... I am not quite as 'senior' as I suspect you are but ... posted by Norman M on January 24, 2015 at 09:39:15:
Inside your phono stage put (or get a tech to put) a voltage-divider on the output RCAs.
This will enable the actual output level to be reduced - the resistor values depend on:
1. the current output impedance of your phono stage
2. the output signal level of your phono stage, and
3. the output signal level of your CDP.
I can give you the values if you give me the answers to the above facts. Davey could, too.
Regards,
Andy
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- There is another simple possibility (which Davey alluded to) ... - andyr 13:13:55 01/24/15 (0)