In Reply to: RE: Tweeter Ribbon Assistance Needed for Maggie 3.3R posted by plschlesinger@aol.com on August 17, 2014 at 07:26:06:
I used a quick connect tab glued on the block and use back the original screw and clamp for the ribbon. You need to drill a small hole through the quick connect tab (for the clamp screw) before mounting it on the block. Make sure ribbon contact areas/edge are very smooth/rounded.
Check that your tweeter wire has enough slack to reach the new terminal.
http://marcomanuf.com/HTM%20PAGES/SPEC%20FILE/3000spec%20page.htm
Take a look at Top Hardware QC Tabs.
The quick connect tab that I used looks like type QC26.
Type QC19 might be better if the narrow part is wider than the ribbon.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Tweeter Ribbon Assistance Needed for Maggie 3.3R - ngchaisoon 05:56:59 08/18/14 (0)