In Reply to: RE: MGIIIa tweeter question posted by Davy on August 12, 2014 at 13:27:36:
Dave,
You can look at www.shackman.deReiner Römer does the new Mylar. The re-wiring is done by a friend of mine.
Prices are higher than at Magnepan but no problem with customs as it is within EU. In the end cost is similar to sending them to Magnepan. I visit Germany regulary (my wife is german) and that make shipping easier.
Tympani I - IV, Bass, new film and wire panel 300.0 €
Tympani I - IV, MT/MHT, new film and wire panel 200.00 €
MG I/II. Bass/MHT, new film and wire pair 790.00 €
MMG/SMG, non quasi ribbon, new film and wire pair 650.00 €
MG 0.5 - 12 pair 286.00 €
MG3.x Series, Bass, MHT, new film and wire pair 1250.00 €
Sheila at Magnepan wrote:"The 40" and 60" are 2 ohm and the 60.6" is 3 ohm
I don't know about a 3 ohm for the T4a, they use a 60" tweeter."I think even a 3 ohm ribbon would work in the older ribbon cage. Could not be all that important if the gap between the magnets is a bit wide, it is a matter of about 1 mm each side of the ribbon.
Edits: 08/13/14 08/13/14 08/13/14
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: MGIIIa tweeter question - Roger Gustavsson 22:55:54 08/12/14 (3)
- RE: MGIIIa tweeter question - Davy 05:50:49 08/13/14 (2)
- RE: MGIIIa tweeter question - Roger Gustavsson 07:48:35 08/13/14 (1)
- RE: MGIIIa tweeter question - Davy 05:08:25 08/14/14 (0)