In Reply to: RE: Foil Project for IIIa's posted by Satie on February 26, 2012 at 12:54:51:
Satie - I wanted to report that all soldering is done on the speakers to the foil and wire runs. All that is left is to do hookup wire to the XO box that is being built. I took a reading on both runs and they are as follows: foil midrange = 4.2 ohms; wire bass = 4.3 ohms. It looks as if they are right where they should be correct?
Did you see my post on the Monarchy SM 70 Pro? If not they have a special online for $588 plus shipping. They are good to 2 ohm intermittent and 3 ohm continuous. Will this work for the tweeters? If so I have narrowed down my selection to the SM 70 or possibly a Factory Built Class D 4 channel (2XSDS-254 modules) which is bridgeable. There is one on Audiogon for $700. I have a Maggie center speaker to throw into the mix as well. It would be nice to be able to use it. Once again thank you for any input!
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Foil Project for IIIa's - computerman 15:02:33 02/26/12 (1)
- RE: Foil Project for IIIa's - Satie 14:41:14 02/27/12 (0)