In Reply to: RE: MMG MiniDSP and bi-amp Questions posted by Davey on February 24, 2012 at 08:58:51:
100% in agreement on both counts.The Tazmon tweak worked for me because I had the feedback from mic measurements. It didn't take long for me to see that the low pass was not right. I used the 2.2mH instead and things began to fall in place. Pity that the HP has to waste so much energy as heat. Shy of a line-level xover, it sounds delightfully clean and extended. We should insert clarifications for this mod.
Later, as I went on to line-level filtering, once again the feedback from the measurements showed what you just said with regard to the MMG modeling.
Edits: 02/24/12
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: MMG MiniDSP and bi-amp Questions - JBen 12:04:42 02/24/12 (0)