In Reply to: RE: An impactful but inexpensive tweak posted by magiccarpetride on May 21, 2010 at 13:17:52:
MCR,
WHile I dont have a, I do exhibit B in your poor slobs statement.
I had planned to do a full write up on the dynamat experiences and the final recipe I went with.
Anyhow, I can see about doing that soon.
But the jist of it is that you remove the socks and put strips around the driver frame where the mylar side is, and on the pole pieces.
Just dont put it at the bottom on the mylar side.
Here are some links:
for the driver frame: http://www.audioasylum.com/cgi/vt.mpl?f=mug&m=145842
for the pole pieces: http://db.audioasylum.com/cgi/m.mpl?forum=mug&n=145929&highlight=dynamat+Dawnrazor
The last link has a pict that is for show. One should do the whole panel, not just the few I showed.
Cut to razor sounding violins
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: An impactful but inexpensive tweak - Dawnrazor 15:45:57 05/21/10 (0)