WIth the Maggie staples and the brackets to better hold the panels in place.OK I have been wanting to do this but I just can't find anything that is premade and ready to go for that application.
Any how, I was reading Taz's DIY sub, where he had the following instructions for mounting the 18" woofer:
--8. With the speaker cabinet on its back. Silicon glue the drivers to the board, NO SCREWS. Trust me it works better and it will hold the drivers in fine. Let glue set for 24 hours. Its best to have the wires connected before you do this. Its also a good idea to just run wire straight from drive to amp, no jacks or plugs in-between.--
SO I am thinking that if a bit of glue could hold 18" drivers in place that have to weigh more than the MMGs whole pannel, and move more...why not use it for your mod and use glue in place of staples.
Ok I can see that if one wants to remove the panel, it isn't going to happen. Besides that, could this work??
This post is made possible by the generous support of people like you and our sponsors:
Topic - Andyr question about your mod - Dawnrazor 22:44:57 12/03/06 (4)
- Re: Andyr question about your mod - throwback 10:02:28 12/06/06 (0)
- Hi DR ... - andyr 00:39:25 12/04/06 (2)
- Re: Hi DR ... - jharris 08:54:11 12/04/06 (1)
- Re: Hi DR ... - andyr 11:37:10 12/04/06 (0)