K&K Audio / Lundahl Transformers Welcome! Need support, you got it. Or share youe ideas and experiences. |
|
In Reply to: Counsel needed for OT for 4p1l line stage posted by rickmcinnis@dogwoodfabrics.com on September 5, 2014 at 14:11:35:
For an application below 500Hz there's no real basis to choose between the LL1660 and the LL1692A. I use the LL1692A instead of the LL1660, because the somewhat lower impedance of the LL1692A pushes any circuit resonances (peaks in frequency response) further above 20kHz compared to the LL1660. I've not measured the higher than 20KHz frequency response yet, so this is only theoretical, but it has worked for other lower Rp tubes in the past.
Kevin Carter
K&K Audio
www.kandkaudio.com
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Counsel needed for OT for 4p1l line stage - KevinC 16:27:34 09/05/14 (0)