K&K Audio / Lundahl Transformers

Posted by KevinC (M) on November 14, 2007 at 07:12:47

In Reply to: RE: CCS for long tail driver board on Dynaco MK III - Kevin?... posted by raq on November 14, 2007 at 05:47:23

You will have to measure the voltage drop and calculate the current using Ohm's law and the value of the resistor. You can then set the current source for this current value before you install it. There are current setting instructions with the current source kits. You will likely need the small heatsink kit for this application.

Kevin Carter
K&K Audio
www.kandkaudio.com

• measurements - raq 11:26:48 11/15/07 (4)
  • RE: measurements - KevinC 13:04:16 11/15/07 (3)
    • R13 - raq 13:07:49 11/15/07 (2)
      • RE: R13 - KevinC 14:05:00 11/15/07 (1)
        • thank you - raq 08:56:03 11/16/07 (0)
• RE: CCS for long tail driver board on Dynaco MK III - Kevin?... - raq 07:23:48 11/14/07 (0)

Post a Followup:

---

[ Follow Ups ] [ Post Followup ] Thread: [ Display  All  Email ] [ K&K Audio / Lundahl Transformers ]
[ Comment ] [ Edit ] [ Delete ] [ Copyright Warning! Click for Details ]

---

[ Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2007, Audio Asylum, all rights reserved ]

---

[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]

---