Tanker:Instructions for wiring Lundahl 1676 with stepped attenuator-final draft!

K&K Audio / Lundahl Transformers

Welcome! Need support, you got it. Or share youe ideas and experiences.

Ok, here is what you do:
A) Download the Lundahl 1676 PDF file and read it, its on Lundahl's website.
B) Remember to look at the 1676 from the COMPONENT side and **not** the PIN side. In other words, it is mapped out as if you are looking at the transformer from the top, using x-ray vision to see the pins underneath. Mark the pin numbers with a pencil so you don't goof!
C) For wiring it 1:1 do this:
1. Connect pin 6 to pin 10
2. Connect pin 7 to pin 9
3. Designate pin 6 as your input and connect this to your RCA jack signal IN.
4. Connect pin 10 to ground and to the ground tab of your RCA jack.
5. Connect pin 1 to pin 4.
6. Connect pin 2 to the signal IN part of your attenuator.
7. Connect pin 5 to ground.
8. Connect pin 8 to ground.
Best,
Anand.

This post is made possible by the generous support of people like you and our sponsors:

The Cable Cooker

Topic - Tanker:Instructions for wiring Lundahl 1676 with stepped attenuator-final draft! - AnandR 06:00:50 11/06/04 (3)

Anand! where you connect pin 7 and 9 to? - Tanker 12:35:12 11/06/04 (1)

You just leave them connected to each other, in blissful harmony! (nt) - AnandR 04:54:40 11/07/04 (0)

Thanks. Anand. - Tanker 12:28:41 11/06/04 (0)

You can not post to an archived thread.