|
K&K Audio / Lundahl Transformers Welcome! Need support, you got it. Or share youe ideas and experiences. |
|
|
|
K&K Audio / Lundahl Transformers Welcome! Need support, you got it. Or share youe ideas and experiences. |
|
In Reply to: 1660 data sheet question posted by Tre' on September 10, 2004 at 12:21:45:
Sorry, but it is true. However, the peaking typically occurs above 20kHz, often way above. It bothers some to see those frequency response aberrations, but I have found that adding loading resistors usually has a negative effect on the sound, so I don't do it.For other reasons, low impedance drive is still a good objective.
Kevin Carter
K&K Audio
www.kandkaudio.com
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: 1660 data sheet question - KevinC 14:25:20 09/10/04 (3)
- Re: 1660 data sheet question - Tre' 14:31:33 09/10/04 (2)
- Re: 1660 data sheet question - KevinC 17:56:23 09/14/04 (1)
- Thanks (nt) - Tre' 10:17:16 09/15/04 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
