|
K&K Audio / Lundahl Transformers Welcome! Need support, you got it. Or share youe ideas and experiences. |
|
|
|
K&K Audio / Lundahl Transformers Welcome! Need support, you got it. Or share youe ideas and experiences. |
|
In Reply to: Re: Will do Dave, But how can I posted by Dave Davenport on September 9, 2004 at 08:19:22:
Dave,Why not solder in 6K resistors instead of 3K and burn it in for 200 hours and then switch back to 3K or whatever (1.5K in my case since I only need 1 V rms output). That way you can burn it in with 4V rms (or close to it).
Is that what you mean? What is the maximum resistance/voltage you recommend on the output of the passive RAKK dac option to break it in? You could use a cheap resistor and then switch back to the Mills when all is done.
Anand.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Will do Dave, But how can I - AnandR 09:52:21 09/09/04 (3)
- Re: Will do Dave, But how can I - Dave Davenport 12:47:57 09/09/04 (2)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
