|
K&K Audio / Lundahl Transformers Welcome! Need support, you got it. Or share youe ideas and experiences. |
|
|
|
K&K Audio / Lundahl Transformers Welcome! Need support, you got it. Or share youe ideas and experiences. |
|
In Reply to: Kevin: For SET design, how much ripple is too much ripple posted by AnandR on July 16, 2004 at 04:46:01:
Konnichiwa,> But I get to question for an SET amplifier for loudspeakers,
> is 22mV too much ripple?Hmmmmm. Depends upon a lot of factors, but if my experience is anything to go by, then it is 20 - 40db too much ripple for SE, it is almsot too much ripple for a well balanced PP Amp.
My current PP Amp's have around 2mV ripple of the output stage and you can hear the step dwon there from around 20mV ripple. It may not translate directly into audible hum (I find 0.5mV output hum tolerable in most amplifiers) but hum is not all....
Sayonara
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Kevin: For SET design, how much ripple is too much ripple - Kuei Yang Wang 18:16:42 07/16/04 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
