|
K&K Audio / Lundahl Transformers Welcome! Need support, you got it. Or share youe ideas and experiences. |
|
|
|
K&K Audio / Lundahl Transformers Welcome! Need support, you got it. Or share youe ideas and experiences. |
|
In Reply to: 1578xl and 1636 termination? posted by smilinfu@earthlink.net on July 7, 2004 at 13:19:19:
Any microphone needs proper impedance termination and a resistor is usually put across the secondary of the input transformer to load the mic appropriately. The wrong loading will potentially result in uneven frequency response. Perhaps this is what you are hearing. With a 1:10 step-up ratio, the 5K resistor looks like 50 ohms to the mic, which is a bit low. Try a 50K resistor and see how it sounds.
Kevin Carter
K&K Audio
www.kandkaudio.com
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: 1578xl and 1636 termination? - KevinC 17:37:33 07/07/04 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
