|
K&K Audio / Lundahl Transformers Welcome! Need support, you got it. Or share youe ideas and experiences. |
|
|
|
K&K Audio / Lundahl Transformers Welcome! Need support, you got it. Or share youe ideas and experiences. |
|
In Reply to: DC current saturation point (LL1620) posted by Jens Axboe on April 14, 2004 at 07:06:51:
You are on safe ground. The 120mA figure is not a magic number, it's just a specification. With a little more current you will run into saturation at low frequencies a little bit sooner, but I seriously doubt if you could hear the difference between 120mA and 125mA unless you like listening to 20Hz tones. ;=))It could be measured by looking at 20Hz THD at an input level that is close to overload.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: DC current saturation point (LL1620) - KevinC 07:11:05 04/14/04 (1)
- excellent! - Jens Axboe 07:14:28 04/14/04 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
