Lundahl's transformer mounting option ?

K&K Audio / Lundahl Transformers

Welcome! Need support, you got it. Or share youe ideas and experiences.

To everyone that use Lundahl's iron,
Since Lundahl's iron are mounted according to the way it was contructed, I have found in my case that the height of the chasis may (only may) sometimes be a factor in your layout and contructions design.
For example, my chasis is 3 inch height, I was using LL1660. When I try to test the LL1654, it cannot be fited properly into the 3 inch chasis because it is too tall. This has stopped me at that point to try out other OPT. (as I may need to rebuilt the whole pre-amp in order to try out other OPT).
Luckily later I use an L shape mount to hold the LL1654 and thus be able to mount it using the same chasis. i.e. the LL1654 is mounted onto the L shape metal and then the L shape meter mount onto the chasis.
The same will happen to others like the LL1683, the small size power transformer which I very much like to try. Again it is too tall. Can't fit into a 3 inch chasis.
Do you guys have this problem ? It would be nice if Lundahl can produce some fancy L shape mounter !!! Any comments.
Alan

This post is made possible by the generous support of people like you and our sponsors:

Schiit Audio

Topic - Lundahl's transformer mounting option ? - akltam 18:25:41 12/17/03 (3)

Re: Lundahl's transformer mounting option ? - sinewave 17:18:47 12/19/03 (1)

No. - akltam 07:04:40 12/21/03 (0)

Re: Lundahl's transformer mounting option ? - drlowmu 20:25:09 12/18/03 (0)

You can not post to an archived thread.