K&K Audio / Lundahl Transformers Welcome! Need support, you got it. Or share youe ideas and experiences. |
|
In Reply to: ST-70 Shunt regulator issue posted by seanzozo on September 5, 2015 at 00:05:59:
I have some small experience trouble shooting these regulators. You can isolate the reference CCS and check it with a battery and say a 10R load resistor. Measure the voltage drop across the load and check the operation of the CCS.
I made a jig with two old CCSs to test the operation of the Shunt Reg. If you don't want to do that I would just replace the the shunt and drive FETs and stick it back in circuit.
"It is better to remain silent and thought a fool, then speak and remove all doubt." A. Lincoln
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: ST-70 Shunt regulator issue - JKT 13:31:31 09/10/15 (0)