|
K&K Audio / Lundahl Transformers Welcome! Need support, you got it. Or share youe ideas and experiences. |
|
|
|
K&K Audio / Lundahl Transformers Welcome! Need support, you got it. Or share youe ideas and experiences. |
|
In Reply to: Re: any amorphous core tr. for 1:8 ratio and balanced input? posted by MaciekP on September 30, 2003 at 05:18:02:
The connection on the amp end is straightforward and as you have it. You should not connect either one of the signal leads to the amplifier audio ground. On the preamp end I would change your output transformer wiring. Take a look at the schematic of my phono stage to see how I advise wiring transformer outputs. Some advocate the RC network from Pin 1 of the XLR to chassis; others advise a direct connection. I use a switch to choose what results in the lowest noise.
Kevin Carter
K&K Audio
www.kandkaudio.com
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Balanced cabling and grounding - KevinC 05:46:31 09/30/03 (1)
- Re: Balanced cabling and grounding - MaciekP 07:10:20 09/30/03 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]