Home DIY HiFi Forum

Welcome! Need support, you got it. Or share your ideas and experiences.

RE: Line Outs (?)

216.230.239.206

Thanks for the response.

Excuse my ignorance, but are the different output levels of the TRAM2 intended to put the volume controlled loudness in a desired range for the given amp/speaker combination?

If I tap off the full range amp speaker outs for the sub woofer inputs, does this, in principle, present a frequency spectrum filtered by the characteristic of the full range amp? Does not tapping from the preamp outputs give the flatter, less filtered, original signal?

In the realm of base harmonic periods, is the relative coherence difference for the amp-out tap versus the preamp out tap significant (aurally)?

The sub amp in this case is a NAD 214 bridged to mono, and the SW is a DIY 18 in. Adire Tempest in sealed large cabinet (low pass filter is Marchand circuit).

Thanks.


This post is made possible by the generous support of people like you and our sponsors:
  Sonic Craft  


Follow Ups Full Thread
Follow Ups
  • RE: Line Outs (?) - NewbieBaby 17:07:32 04/23/10 (0)

FAQ

Post a Message!

Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.