In Reply to: DAC Output Stage - order placed! posted by Mikey on December 31, 2009 at 08:13:26:
>DAC pin 26 (L-) to UTS terminal 'in L'
Please remember to connect a 51 Ohm resistor in parallel to in L and to connect Vcom & Gnd.
This gives the correct output levels for a 7.8mA Current output.
> DAC pin 25 (L+) to 22 ohm resistor, resistor to GND
Yes .
> DAC pin 18 (R-) to UTS terminal 'in R'
See notes for L-.
> DAC pin 17 (R+) to 22 ohm resistor, resistor to GND
Yes.
> In the Denon schematic, all four AGND pins (16, 19, 24, 27) are tied
> together....this will be my analog ground, correct?
Yes.
> If correct, let's call this GND.
Ok.
> GND to UTS terminal 'Gnd L'
> GND to UTS terminal 'Gnd R'
> GND to UTS terminal 'Vcom L'
> GND to UTS terminal 'Vcom R'
Yes.
> The schematic on page 22 of the manual shows (4) 51 ohm resistors.
> What do I do about those?
The two for the inputs to the UTS stay, the other two become 22 Ohm.
> I could locate the 22 ohm resistors close to the DAC chip, or I could mount
> them somewhere on the UTS....which is preferred?
Makes little difference, just do what is most convenient to do.
And of course you must disconnect the existing I/V conversion stages in the Denon Player (cut trace or remove Op-Amp and Op-Amp feedback resistor).
regards
DIY - Done Right!
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: DAC Output Stage - order placed! - bcherry 16:53:41 01/02/10 (7)
- Thanks Brian! I found a perfect spot... - Mikey 08:29:45 01/04/10 (6)
- RE: Thanks Brian! I found a perfect spot... - bcherry 04:53:53 01/05/10 (5)
- UPDATE! - The 'Universal Tube Output Stage' has been installed.... - Mikey 08:50:05 01/18/10 (4)
- RE: UPDATE! - The 'Universal Tube Output Stage' has been installed.... - Thorsten 08:41:15 01/19/10 (0)
- RE: UPDATE! - The 'Universal Tube Output Stage' has been installed.... - bcherry 01:47:49 01/19/10 (2)
- RE: UPDATE! - The 'Universal Tube Output Stage' has been installed.... - Gnnett 21:53:58 01/23/10 (1)
- RE: UPDATE! - The 'Universal Tube Output Stage' has been installed.... - bcherry 21:56:25 01/24/10 (0)