DIY HiFi Forum

RE: splitter box with balanced in and two isolated single-ended out?

218.189.230.244

[ Follow Ups ] [ Post Followup ] Thread: [ Display  All  Email ] [ DIY HiFi Forum ]

Perhaps a simpler solution; drive the plate amp from the speaker outputs into the low level inputs through a 2K (or so, adjust to get the sensitivity right) resistor. Since the input impedance of the low level inputs is probably in the 20-100K range it will have very little effect on the impedance seen by the amplifier, plus the sub gets the same signal as the speakers for greater coherence.
Brian
Take control! DIY.

Follow Ups:

Post a Followup:

FAQ

Post a Message!

 Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.

[ Follow Ups ] [ Post Followup ] Thread: [ Display  All  Email ] [ DIY HiFi Forum ]
[ Comment ] [ Edit ] [ Delete ] [ Copyright Warning! Click for Details ]
[ Top Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2007, Audio Asylum, all rights reserved ]
[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]