Tech Square

Technical and speculative discussion of amps, cables and other topics.

Return to Tech Square


Controlling inductor vibration

71.204.54.207

Posted on September 10, 2009 at 20:23:22
bevo
Audiophile

Posts: 307
Joined: December 27, 2004
Any concerns about doing something to damp vibration on plain oil wire coil inductors? I was thinking of using two vertical "stripes" of hot melt (doesn't get rock hard) to eliminate the vibration, but am not sure that won't have unintended consequences. Comments are much appreciated.

I'm a little late to the party..., posted on September 21, 2009 at 14:12:03
SF tech
Industry Professional

Posts: 5219
Location: San Francisco
Joined: March 24, 2005
Contributor
  Since:
February 4, 2008
Are you talking about the coils at the amp's output?

I've only heard them ringing near maximum power output at high frequencies.

How about a piece of appropriate diameter heat-shrink?

Easier to remove than glue if you don't like the result.

SF





RE: Controlling inductor vibration, posted on September 13, 2009 at 07:51:26
b.l.zeebub
Audiophile

Posts: 810
Location: 52deg 28'N,1deg56'W
Joined: April 17, 2006
The best thing you can do to control crossover inductor vibration is to get an active crossover and eliminate the inductors altogether.

Although this is probably not what you wanted to hear.

RE: Controlling inductor vibration, posted on September 13, 2009 at 18:19:08
bevo
Audiophile

Posts: 307
Joined: December 27, 2004
Actually, this inductor is in my amp (Bryston 3B), so I don't think I can avoid it. Thanks though.

RE: Controlling inductor vibration, posted on September 14, 2009 at 06:42:39
b.l.zeebub
Audiophile

Posts: 810
Location: 52deg 28'N,1deg56'W
Joined: April 17, 2006
In this case i would just stop worrying.

Unless your amp sits on top of a subwoofer or you tend to use a jack hammer while listening.

Page processed in 0.077 seconds.