Tympani 1D Connection Help

70.241.70.117

Posted on October 20, 2009 at 09:19:18

Tim01

I have a pair of Tympani 1D that I have bi-amped through an active crossover with twin powered subs. Recently I discovered an online version of the owner's manual and it shows a wiring diagram different than the way I am presently wired. Could some one here tell me the proper connections and placement of jumpers?

RE: Tympani 1D Connection Help

14:28:45 10/31/09

RE: Tympani 1D Connection Help

andyr

00:25:24 10/21/09

RE: Tympani 1D Connection Help

Door Nail

21:29:55 10/20/09

RE: Tympani 1D Connection Help, posted on October 31, 2009 at 14:28:45
monk1	What crossover frequencies are you using in your T-1D setup? Is the T-1D woofer panel operated down to its lower limits or are you rolling off the bass into the woofer panel using the sub's internal crossover? What amplification are your using?

RE: Tympani 1D Connection Help, posted on October 21, 2009 at 00:25:24
andyr Audiophile Posts: 6564 Location: Melbourne Joined: September 2, 2000	Hi Tim, Someone sent me a couple of emails last year with T-1D wiring and XO schematics. If you'd like to PM me your email address, I'll send them on to you. Regards, Andy

RE: Tympani 1D Connection Help, posted on October 20, 2009 at 21:29:55

Door Nail
Audiophile

Posts: 700
Joined: August 27, 2005

First there are early and late 1Ds. The early ones have screw terminals and the late ones have banana jacks. If you are bi-amping the 1Ds you don't use any jumpers. The early ones show tweeter + and - and mid/bass + and - and the late ones show a schematic of the drivers + and - crossover and jumpers. In either you just connect the tweeter amp to the + and - tweeter terminals and the low frequency amp to the + and -mid/bass terminals.

Page processed in 0.298 seconds.

Planar Speaker Asylum

Tympani 1D Connection Help

70.241.70.117