Posted by agedashi (A) on September 30, 2006 at 01:00:34

In Reply to: Re: Jordans array posted by bcherry on September 29, 2006 at 15:09:55:

Thanks Brian,

You prempted my question about integration with the dynaphon! I only have a few hours on the JXR6's and the highs are still a little rough. How long did you have to break them in for?

regards

ag

• Re: Jordans array - bcherry 01:58:10 09/30/06 (2)
  In Reply to: Re: Jordans array posted by agedashi on September 30, 2006 at 01:00:34:

  AG

  I ran them in a couple weeks, but never found the highs to be rough; it was more a case of them opening up and becoming more extended and relaxed as they ran in. It is a very smooth driver and very revealing, more like a ribbon than a cone in performance.

  cheers
  Brian
  
  Take control! DIY.
  
  

  ---

  • Re: Jordans array - agedashi 15:03:22 09/30/06 (1)
    In Reply to: Re: Jordans array posted by bcherry on September 30, 2006 at 01:58:10:

    Thanks Brian,

    I'm using them open baffle (6db High pass at 280hz) but they are 600mm from the rear wall, so I think the reflected wave may be effecting things. I'll drag them out and see and also try a sealed enclosure. I assume your boxes are sealed, are you using the same volume as per the Jordan web site, approx 6.6L per driver? One , more question, are you using a 3 x 3 loom to wire the drivers?

    thanks and regards

    ag
    
    

    ---

    • Re: Jordans array - bcherry 17:38:19 09/30/06 (0)
      In Reply to: Re: Jordans array posted by agedashi on September 30, 2006 at 15:03:22:

      AG
      The net volume of the box is 16L, sealed and starts to roll off ~150hz.
      The Jordan JXr6 have no rear suspension (free-to-air) and are not suitable for an open baffle. You will get a very different sound in a sealed cabinet.
      Yes driver wired 3 x 3. Keep us posted.
      Brian
      Take control! DIY.
      
      

      ---

Post a Followup: