Vinyl Asylum

Posted by ecir38 (A) on July 12, 2007 at 07:36:46

In Reply to: RE: Seems like it would depend on the LOMC you're using... posted by tketcham on July 11, 2007 at 21:26:05

Sometimes i have to much time on my hands.

If we knew the spacing of the resistors pins i was thinking that it may be possible to find a pcb socket to go in place of the the resistors. It looks like there would be enough room to allow this. This way if you change the cart and wanted differant loading options the resistors could be removed and replaced without soldering.

I was thinking something like a through hole led socket or ic socket.

Edits: 07/12/07

• RE: pcb socket - tketcham 17:48:54 07/12/07 (1)
  In Reply to: RE: pcb socket posted by ecir38 on July 12, 2007 at 07:36:46

  Very interesting idea. The ultimate in loading versatility! I have no suggestions other than try it and see.
  
  Tom
  
  

  ---

  • RE: pcb socket - ecir38 17:57:36 07/12/07 (0)
    In Reply to: RE: pcb socket posted by tketcham on July 12, 2007 at 17:48:54

    Check these pdf's out.

    http://www.imperial-connect.co.uk/products/btb/I5B.pdf

    http://dkc3.digikey.com/PDF/T072/P1600.pdf

    Just need someone with a blank board to measure the pin layout to get the right one. They make 1mm, 1.27mm, 2mm and 2.54mm,. My guess is that the one above might be the right one. I also found some with single socket's but have to look at them better.
    
    
    
    

    ---

    Edits: 07/12/07
• If it could be done without affecting the sound. That's the question. /nt\ - HenryH 08:09:19 07/12/07 (1)
  In Reply to: RE: pcb socket posted by ecir38 on July 12, 2007 at 07:36:46

  
  
  Henry

  Mushrooms are the opiate of the mooses
  
  

  ---

  • RE: If it could be done without affecting the sound. That's the question. /nt\ - ecir38 10:38:41 07/12/07 (0)
    In Reply to: RE: If it could be done without affecting the sound. That's the question. /nt\ posted by HenryH on July 12, 2007 at 08:09:19

    I don't think there would be a problem as long as the socket used made a good connection to the resistor. The trick would be to find the right socket.
    
    
    

    ---

---

[ Follow Ups ] [ Post Followup ] Thread: [ Display  All  Email ] [ Vinyl Asylum ]
[ Comment ] [ Edit ] [ Delete ] [ Copyright Warning! Click for Details ]

---

[ Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2007, Audio Asylum, all rights reserved ]

---

[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]

---