|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
76.29.30.186
In Reply to: RE: Significant upgrade to my Linn LP12? posted by Lt Einhorn on December 19, 2014 at 14:34:24
The pre-Cirkus bearing's mounting flange is flat, and meets the round bearing housing at a right angle. The Cirkus bearing's mounting flange gets thicker on the bottom as it gets closer to the bearing housing - it has a triangular cross section. You'll need to take the bottom off your table to see which you have.
Follow Ups:
Thank you for the information :)
This is the Cirkus bearing.
And these are non-Cirkus bearing.
Altho, you can purchase a bearing alone, it is recommended by the factory that the inner platter and new bearing should be a matched piece to ensure the right fit. Also, be aware that the older inner platter sometimes does not fit the newer outer platter.
Great! Ill half to take a look now. Im betting i do not have that. Much appreciated!
After chatting with you folks, sounds like the LP12 still competes with modern tables. Looks like doing some upgrades and a good tuneup will get me far.
Post a Followup:
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: