|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
97.95.43.235
In Reply to: RE: I'm curious how that unit sounds with the mods it has as far as the tubes go? posted by Oface on July 08, 2016 at 17:09:58
Its 12 and 3/4 long and 2 and 3/4 deep but what I'm going to do is pull off the bracket and draw a template and mail it to you..I will pull the cans off and trace the bracket onto some paper;
"
"For every complex problem there is an answer that is clear, simple, and wrong" H. L. Mencken
Follow Ups:
Also the holes for mounting the caps are 1.375" diameter except the one for the old bias cap which is at the opposite end of the bracket from Mike's picture. But I'd make it the same size as the others since modern clamp mount caps caps fit well with those size holes.
Thanks for the diameter measurements Jim!
Mike said he'll send me a drawing of the bracket, I think that and the measurements should be good for my friend.....
Thanks again all!
-chris
Make sure the bracket is thick enough, and also make sure you look carefully at the picture I posted for where the clamps mounting holes go along with the other holes in the bracket. The same goes for the bracket-to-chassis mounting holes.
Jim
I think it's like 10ga,right?
"For every complex problem there is an answer that is clear, simple, and wrong" H. L. Mencken
Thanks Mike!
Post a Followup:
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: