|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
73.226.116.199
I was tinkering with a junker and lifted a solder pad off. You do know that with SMD there is NOOOOOOO way in hell you can repair that!
Luckily like I said it was a junker I found. But I do have three pieces that are constructed mostly with SMD boards. And I WAS tempted to try some different capacitors out on them. Now - ain't no way I'm fooling with those. I like big clunky discrete components. Maybe even bigger - tubes!
Follow Ups:
I've dabbled in SMD with hot air rework. I built a software defined radio receiver where a majority of components were surface mount. It was quite the learning experience. Good lighting and a magnifier is a must.
The trouble with modern components, IMHO, is the use of all-tin solder, which is harder to get hot enough. I used 50/50 tin-lead paste. (I don't have to adhere to RoHS rules ;) )
I made one mistake of installing a 16 leg chip where it wasn't needed. With the hot air station, I was able to remove it without destroying the part or board. Old school solder irons with blunt tips don't work so well.
The most fun part is watching a part work itself into place by surface tension of the solder.
"Always remember, Any plan where you lose your hat is a bad plan." The Jägers
All is not lost, with the lifted pad. You can save the day using conductive, silver bearing, epoxy. However, that stuff is damned expensive.
I too have little love for SMD parts. There's no way in Hell I'm getting involved with solder paste and ovens. :> (( If SMD parts are the only way to solve a particular problem, I'll bite the bullet and buy the conductive epoxy.
Eli D.
I got good at SMD but a heat gun for removal is key IMO. My big issue is there aren't really good SMD parts.
ET
FWIW, I've seen some Schottky bridges that looked interesting.
Eli D.
I do believe there will be better parts as time marches on. I'll continue to watch.
ET
I agree,
SMD is evil, and should be confined to consumer products not likely to be repaired.
Proudly serving content-free posts since 1984.
They are, ain't no way you're fixing those boards!
It breaks - it's landfill.
Post a Followup:
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: