|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
67.85.217.205
In Reply to: RE: IMO ... posted by dee eye why on December 12, 2014 at 15:16:34
This was posted on the Classic Speakers (Mostly AR & KLH) forum regarding Bold eagle's resistor tweak:
Hello everyone,
Since I've received so much help on this forum, I'd thought I'd share a very pleasant experience with you.
A couple of weeks ago, in the Vintage section of the Audio Asylum, there was a discussion about using Solid State (SS) amps that have a high damping factor (>100) with vintage speakers. One of the points made was that vintage speakers designed in the 50's thru the late '60's were voiced with tube amplification in mind.
It was mentioned that when AR was doing demos in the AR room during the 60's, they were using MAC's and Dynas for amplification.
One of the posters (Bold Eagle), suggested that a resistor (.5 to 1.5 ohm) wired in series with the speaker would present a speaker load to the amp more in keeping with a tube amp.
Since I have a pair of AR3's powered by a NAD C350 (60 watts rms/channel into 8 or 4 ohms) that has a high damping factor (~150), I asked Bold Eagle in a private email about applying the resisitor tweak in my system.
He responded as follows:
"Be happy to help you with this. I, too, have the NAD C350. It's a very well designed amp. But it has a very high Damping Factor (low source impedance). Tube amps have a low Damping Factor (high source impedance). So adding series resistance to the C350 gives it the impedance characteristic of a tube amp."
I purchased two .5 ohm power resistors, and wired them in series on one leg of each speaker cable. Total cost, $1.05. (I also purchased a pair of 1 ohm and 1.5 ohm resistors, but haven't tried them yet to see how increasing the resistance impacts the sound).
The results:
First, the biggest impact was that the whole mid-range and upper mid-range seemed to become much smoother. Next the treble seemed to have slightly better clarity. Finally, the bass seemed slightly more defined - a little less muddy if you will. Huge improvement? No, but noticable, and quite pleasing.
Am I hearing something better, or something thats just different? I don't know for sure yet. I spent some time switching the resistors in and out of the cables, and I like what I hear better with the resistors in the circuit than out of the circuit, so they're staying in.
I don't know if this tweak will work with more 'modern' AR speakers, but I would surmise this might work with the AR1 and AR2 series speakers as well.
If anyone else tries this, or has tried this, let me know what you think.
Regards,
Larry
Follow Ups:
nt.
.
Freak out...Far out...In out....
Post a Followup:
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: