 
|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
|
|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
In Reply to: Help with cutting aluminum posted by Tightwad on February 10, 2003 at 09:02:48:
you may not believe this. I use a circular, table or radial saw with a normal 40-60 tooth carbide blade. cuts like butter. I have cut 2" stock - slowly.
Follow Ups:
I do the same. I bought a special Craftsman 60 tooth carbide blade made especially for laminates and aluminum. Works better with some sort of lubrication. I usually spray on lots of WD-40 while cutting.
This post is made possible by the generous support of people like you and our sponsors:
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2013, Audio Asylum, all rights reserved ]
[ Take5 ]
