|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
104.166.248.226
In Reply to: RE: Some fiddling and some discoveries... posted by MannyE on November 06, 2016 at 15:28:36
125A/250V 5x20mm SLO-BLO fuses.
125 amp? I am pretty sure you mean 1.25 amp? A 125 amp 250V fuse is a pretty big fuse. Amperage as well as physical size.
I then proceeded to (after disassembling the whole deadly thing, the reassembling with the board) connect the red and black and orange and yellow to the board.
Are you 100% sure you hooked up the secondary windings correctly?
Did you parallel the two windings so they were in phase with each other? If not the two winding will buck one another and that would blow the fuse protecting the transformer.
Winding #1
Blk and Red leads.
Winding #2
Org and Yel leads.
To parallel the two windings,
Connect the Blk lead and the org lead together. (This becomes one hot leg of the 15Vac that will feed the board)
Connect the Red lead and the Yel lead together. (This becomes the other hot leg of the 15Vac that will feed the other terminal on the board.
Follow Ups:
Are you 100% sure you hooked up the secondary windings correctly?
Ah! No! I did not do that. I will try it as you say and report back. Since there were two blocks on the board to connect A/C I assumed it was one block for each winding.
Where is the schematic wiring diagram for the board? I wouldn't hook up anything to the board until you know for sure what's going on with the two AC terminal blocks.
Post a Followup:
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: