|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
128.115.190.40
In Reply to: RE: Best size drill bit to open up circuit board holes?? posted by Tweaker456 on April 07, 2016 at 13:23:44
Well, what size is the component lead? The industry rule is the hole should be a min. of .006 over the max lead diameter, and a max of .020 over the max lead diameter. Any larger and the solder has a difficult time flowing properly.
Follow Ups:
Hornlover to the rescue again. The op amp pins are about .02. That would put it at a minimum of .026. I ordered up some .028 bits. Should work. Thanks, Tweaker
In you OP you said " in ALL through holes in circuit boards".
Post a Followup:
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: