|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
74.177.126.14
In Reply to: RE: Not only interesting posted by jedrider on November 17, 2014 at 13:04:14
From Belleson's web site:
"Drop-out voltage is as low as 1V at currents to 2A for the SPJ version."
If you are talking about my Graham Slee phono stage board being designed for one regulator, that's true, if you're only looking at the main phono stage. But in my "review" of the Belleson, you'll note that I stated that the Slee came with an external DC power supply, which is regulated to 24V, and then regulated again inside the phono stage to 18V.
The reason I mentioned pre-regulation is because fmak said "Pre regulation into this array is even better.", and according to Belleson, pre-regulation becomes not only unnecessary, but undesirable.
Follow Ups:
of your circuit.
You're using the 'regulated' term loosely. The DC can be rectified ADD filtered, but when you put it through a regulator, it 'drops' the voltage AND consumes some energy doing so. There are 'low drop-out' regulators, but I hear that they are undesirable because they are noisy or something, so most regulators are full drop out, typically about 2.5V. Only something to worry about if you are inserting into an existing circuit, and if all you do is replace one regulator with a similar, but better, one, the voltages hardly change.Most gear can run within a range of voltages AFAIK. Usually +-10% is expected, but I believe a greater range is often possible, if one is stuck with a particular transformer, for instance.
Edits: 11/17/14
At the risk that I misunderstand you, not all voltage regulators drop the same voltage in order to achieve regulation. The voltage dropped will relate to the impedance of the particular regulator and the amount of current drawn by the downstream circuit, as someone else also mentioned. Furthermore, typical voltage regulators require a restricted range of input voltages, in order to regulate properly, in relation to the desired output voltage. Not too much (which can damage the regulator due to heat) and not too little.
I used the term 'regulated' to describe a DC power supply circuit which contains a voltage regulator, and in the case of my (pre Belleson) Gram Slee, two regulators in series. How do you conclude that to be used 'loosely'?
"There are 'low drop-out' regulators, but I hear that they are undesirable because they are noisy or something"
Fmak, the original poster, started a topic regarding Belleson Superpower regulators specifically, which is what I'm commenting on. The Belleson is a low drop-out regulator, and if you look at the measurements on their web site, they're not at all noisy 'or something'.
Post a Followup:
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: