|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
99.241.205.115
In Reply to: RE: Tube Power Amp Not Working - Help? posted by capone on September 05, 2015 at 19:27:47
Well, I know little about your amp, but there are some basic things you could check.
I tried looking for a schematic, but no dice. That makes it a lot easier to direct you through checking some things with your volt meter...
Well, either way, I'd check if you have any B+ reaching your tubes, and see if there's maybe a high-tension fuse inside the amp that's gone. The fact your 5AR4's don't glow isn't a huge concern, but they should still at least a little - they have a heater wire like any other tube.
To check the B+, I just take out my main power tubes, connect the red lead into the pin connected to the tube's plate, and then the black lead to the best relevant ground (could be chassis, but largely depends on circuit). When you turn on the amp, and off standby, you should see B+ voltage of a few hundred volts.
If you don't have B+, bring it in to a tech.
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
May your tubes be warm, long-lasting, and always lively. Holy be thy heater.
Follow Ups:
Thank you so much for your guidance so far. I am wondering - if the rectifier tubes are blown, would total silence be the result? I'm trying to start with an easy fix before I get more technical.
Thanks!
Total silence would be the result, in theory. Suppose the rectifiers are blown OR that the B+ fuse is fried, there will be no voltage reaching the valve's plates, no draw, and no sound. So, the valves are effectively offline, regardless of whether heater's are a'glowin.
Another consideration that just occurred to me is the design of the 5AR4 itself. While all rectifiers have anodes (plates), the cathode design can vary. Some are have "filamentary" designs, so it's just a filament to source electrons for the anode. However, some have cathodes heated by the filament, instead. Your 5AR4 has a heater and a cathode, and these two parts are INTERNALLY CONNECTED TOGETHER. So, let's say your amp does NOT have a B+ fuse and there was a run away, a sudden rush could have caused an arc between the plate to the cathode of the rectifiers. The 5v filaments would have suddenly seen hundreds of volts, effectively overloading and killing the tubes.
And not to scare you, it could have damaged the 5V heater winding of the transformer... Tube rectified amps have 6.3v and 5v windings; the 6.3v for pre-amp and power amp tubes, and the 5v solely for rectifiers. If you replace the rectifiers, and they STILL don't turn on... I'd be very concerned as it may indicated the 5v winding has suffered an overload and burnt.
I found an interesting resource that may be of use to you. Check it out :)
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
May your tubes be warm, long-lasting, and always lively. Holy be thy heater.
Edits: 09/07/15
if the rectifier tubes ARE blown, dont just plug in new ones, you uneed to figure out what caused them to blow first, or you may blow the new ones also.
Thank you all so much for your advice. This forum is amazing. I'm so glad I found it now that I have all tube hi-fi gear. That said, the simple fix did the trick: new rectifier tubes. The amp sounds beautiful.
Post a Followup:
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: