|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
24.140.192.106
In Reply to: RE: Zener diode posted by FenderLover on September 19, 2016 at 14:22:32
My PS is LCLCRC.
The driver plate supply for both channels is taken off C3.
I had about 100 pieces of 5.1V zener diodes and not so many UF type 1A diodes, so I used the zeners.
Follow Ups:
Each diode is conducting all the time. The effect is essentially no different than if you increased the value of each plate resistor by 200 ohms or so.
--------------------------
Buy Chinese. Bury freedom.
I would probably need to set something up similar to Eli's schematic.
Thanks for the comment.
At the risk of dropping the voltage below nominal value.
Did you notice any changes audible in separation?
Post a Followup:
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: