|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
97.95.43.235
In Reply to: RE: Another thing to consider.... posted by DAK on June 23, 2016 at 17:19:41
Dak
Answer a question.Were you planning on using one triode in each 6SN7 for voltage gain while the using the 2nd half as a follower?.If you CCS load one section of the 6SN7,you will get a gain of 20.I'd run it at about 8ma to 10ma.
I know you only want to get 12 watts but you still want it to be very linear and as far as operating points go,that is more affected by the DC voltage settings than the AC signal. Do you have a schematic to that circuit?
"For every complex problem there is an answer that is clear, simple, and wrong" H. L. Mencken
Follow Ups:
Hi Mike one section of the 6sn7 will drive the power tube, so, only a 2 stage amp Each 6sn7 will therefore drive the 2 se amps that make up the push pull pair for the output trans. The circuit is located here;
http://rh-amps.blogspot.com/2013/05/rh-universal-v2-totally-universal.html
thank you for your interest.
I know you want to build a PP amp with the drivers being single ended for half of the cycle to feed each output tube..If you look tho,they are using the 12AU7 as a voltage gain amp driver and I thought you wanted to use a cathode follower driver..Their circuit has gain and this is where I am confused.You need to use half of each 6SN7 as a voltage amp and the other half as a driver..If you paralled the halves of the 6SN7,you are just going to end up with a lower impedance driver or voltage amp,depending on how you use it.
I heard a superb sounding Single Ended KT88 built by a guy named Kegger and it used Edcor iron and it was driving a pair of ADS 780s but it sounded much bigger than the 10 or 12 watts is was rated at.
"For every complex problem there is an answer that is clear, simple, and wrong" H. L. Mencken
There is no amp as such and i am trying to make one out of 2 of the single ended amps. Phase splitting will be done with a Lundahl input transformer and each mirror imaged signal will be handled by a se amp.
I have built 2 of these that are kt88 type and they sound excellent. So, i was thinking i would make a parallel single ended version to get the power up to 20 watts. Well, that's been done many times and i thought i have not read about anyone taking a se amp and using it as a basis for a push pull amp. So this is where i am now.
Post a Followup:
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: