|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
75.132.155.75
In Reply to: RE: Does anyone see any obvious mistakes of have any suggestions? posted by Chip647 on April 15, 2016 at 17:41:03
Or I could use a AD841 as a buffer. I could use a lot of things. Actually you just relegated most tube preamps that have ever been made to the trash heap. I'm asking whether you see any problems with the circuit as described and have any suggestions on how to make it work better. Not whether IYO it has too much gain. I may want to use it with a tube amp one day. Where I use it is irrelevant. Also I have tried many preamps with a 6sn7, 6sl7. 5687........ etc. The 12au7 is readily available and has low input capacitance which is why I chose it. Plus I like tubes and the way they sound.
Edits: 04/15/16 04/15/16Follow Ups:
You can't listen to a preamp by itself, so it is kind of important what you are planning on using it with. You stated pretty clearly that you want to use it with a Gainclone, thus my comment that it is not the best fit..
It comes down to understanding a "system". Tube amps also have typically sub 1V input sensitivity for full power. Most preamps serve as source switchers and attenuators with way too much gain. When you build your own system you are freed from the constraints of manufacturers having to make their preamps compatible with any any amp and any source. You know yours so design something that is specific and optimized to your system. That is the benefit of DIY.
If you are just looking to build something, yes an active load on a triode will make it function. A cathode follower with an active load will give you lower output impedance.
The 12AU7 has few fans, try a 6CG7 for a 9 pin or one of the other tubes people suggested. Your desire to use AC on an indirectly heated tube is OK to save cost, though it will add noise. People use AC on directly heated filaments for the sound impact, there is no sound impact on indirect heaters with AC except noise.
Heating an indirectly heated tube with AC does sound different from using a DC supply. Some prefer the sound with DC on the heaters; I prefer AC. But whatever your preference, there is clearly a difference.
I'm referring only to IDHTs, of course.
--------------------------
Buy Chinese. Bury freedom.
The 12AU7 triode is non-linear and makes a poor voltage amplifier. Use a linear 12BH7 under the conditions you envisaged.
Eli D.
Post a Followup:
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: