|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
141.239.172.248
In Reply to: RE: Newly built amp was performing well...now oscillating posted by DAK on August 22, 2015 at 02:11:59
I got the amp back from the owner to check on its condition and everything looks ok. I retested all the tubes and they are all good. So, I removed the 5v4 rectifiers and installed some SS rectifiers and did some voltage checks at 80 vac. Voltages look good EXCEPT; the bias circuit.
I have installed an "EFB" circuit which is the brainchild of Dave Gillespie. This uses an LM337 transistor along with an adjusting pot and some resistors and caps. With the EFB I was having a stable output of .56 vdc which translates into about 24 ma static dissipation per el84 tube. The problem is now I am reading 1.5vdc on the test point. Is it possible that the LM337 has failed? Anyway, I put back the 100 ohm 5 watt bias resistors for now and disconnected the EFB. I will run some sound checks and if the amp is stable I will probably just leave it at good ole cathode resistor bias. If the EFB is unreliable I would not consider it an improvement over a cathode resistor. regards, Dak
Follow Ups:
When I first saw the EFB circuit, it occurred to me that even a momentary short in an output tube could destroy the LM337. I don't know if your LM337 is defective, but it might be advisable to install a TVS (transient voltage suppressor) to ground at the output of the chip.
--------------------------
Buy Chinese. Bury freedom.
If that is the case I would rather do with out one. It has been my experience with SS devices that they are too sensitive to over voltage situations which in tubed gear is a very likely occurrence. Adding another component just makes it that much more of humbug versus a single resistor. I am not that savvy with using SS but was willing to give it a try. So, with this unit I gave it a chance, but it only lasted a week before failing. I don't think I can recommend the EFB circuit inspite of its advantages. Reliability is a high priority with me. Best regards, Dak
Edits: 08/24/15
This seems to be another case of tubes being mechanically fragile and electrically tough, while SS is mechanically tough and electrically fragile.
Yes sir, be very careful about exposing SS parts to over voltage, lest they fail. The IRFBC20 and ZVN0545A MOSFETs are favorites of mine in the DC coupled voltage follower role. At this time, I would not call for either FET, unless a protective Zener diode, like that shown in the uploaded preamp schematic, is employed. FETs and other SS parts turn on instantly and voltages are "squirrely" before tube conduction starts.
Eli D.
Post a Followup:
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: