|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
108.67.96.53
In Reply to: RE: ultra-linear plate curves posted by jazbo8 on March 19, 2015 at 10:27:41
That depends on the tube characteristics. It is hard to generalize. For a low voltage 813, I think 20% is very good. The U-L curves depend on where you start; B+ that is. The 47 curves look like they'll like low percentage taps too.
cheers,
Douglas
Friend, I would not hurt thee for the world...but thou art standing where I am about to shoot.
Follow Ups:
Here is the UL characteristic with 20% tap, not sure it does much...
Hi Jazbo8
Thanks for the curves. But you are right they don't look that much
different than the pentode curves. I wonder how the traditional 43%
curves would look?
Cal
You are welcome, here is how it looks at 43%, a bit better...
Thanks again jazbo8.
That does look better. I think I will go with that since these are
easily obtainable "off the shelf" transformers.
By the way what curve tracer are you using for this it does a nice job.
Cal
You are welcome. The graph was not done with a curve tracer though, you can plot the UL characteristics with a simulation program if you have the SPICE model, which was what I did.
Interesting I might have to look into that.
Cal
Post a Followup:
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: