|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
74.103.75.241
In Reply to: RE: replaced diodes/caps in power supply? posted by Chip647 on October 25, 2014 at 06:25:05
Thanks, Chip! I'll give that a go.
I'm committed to film caps in the PS, these were just easy replacements and from what I'd read they would sound much better than existing ... and they did. The outboard PS will take some good size films, but the preamp chassis itself has zero real estate for anything like that so I'd like to find radial-lead, 1 3/8" films that could mount through the existing holes/clamps, but have not seen any candidates yet. I could also probably use round axial types with something close to that dia, but then I'd have to put the ground end up in the air out of the chassis with a wire running back down inside. Kind of kludgy.
Follow Ups:
Take a look here:
http://www.mouser.com/ds/2/88/UNL-9847.pdf
Mouser stocks the 30µF/400V, 35µF/500V and 30µF/600V Cornell-Dubilier radial cylindrical caps in this series. All are 35mm in diameter which is very close to what you need (1.375" = 34.9mm) so if your clamps have a screw adjustment they should fit perfectly.
Yes, they will fit fine. Thanks!
Post a Followup:
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: