|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
24.140.98.34
In Reply to: RE: It would be interesting to see the sweep with a speaker as a load posted by Chip647 on April 05, 2014 at 06:54:23
I hooked up some Optimus Pro LX5's as a load for the OPT secondary.
Just ran the signal into 10:1 attenuator probes to the soundcard.
A microphone would probably have a different looking graph because of the room acoustics or whatever.
The sweep is not razor flat, but I was not expecting it to be with a speaker load.
This is the best I can do until I get a bit more familiar with FFT measurements.
Follow Ups:
That would get back to a 5k load .
Keep it up, doing a great job.
The measurement was taken on 5K primary tap w/8 ohm speaker.
Post a Followup:
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: