|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
82.47.215.155
In Reply to: RE: SE 2A3 beta follower : spectrum graph @ 1W , finals biasing posted by deathtube 667 on March 27, 2014 at 20:06:50
Hi Dt,
I use a 5k opt on my dc45 but use 8 ohm taps for 16ohm speakers, this presents a 10k load to the finals.
Could you try something similar to increase the opt load or change the opt to a 5k.
If I understand correctly, this gives lower distortion with only a few mw reduction in power.
Headroom and dynamics are unbelievable on my horns.
Smart
Follow Ups:
I tried a 5K plate load for the 2A3. Didn't change anything else.
Here are THD measurements :
4.3% @ 1W , 3.1% @ 3/4W, 2.1% @ 1/2W and 1.15% @ 1/4W.
Spectrum at 1W RMS:
Fundamental : 1KHz sine wave @ 0dB
2nd harmonic : -28.41dB
3rd harmonic : -41.50dB
4th harmonic : -67.84dB
5th harmonic : -65.60dB
The performance is a little better, but still not optimal.
I will try again the 2.5K plate load and higher bias current.
-28db is 4%
Something isn't right.
A 2a3 at 1 watt should not have 4% 2nd harmonic distortion.
Is your driver stage clean?
Is you audio signal generator clean?
Tre'
Have Fun and Enjoy the Music
"Still Working the Problem"
I compared both external AF generator vs. internal signal generator.
@ just over 1W output with 1.327VAC input sine wave:
external AF generator measured : 3.75% THD
internal signal generator measured : 3.41% THD
The internal generator is a bit cleaner.
Still using the 5K plate load and biased at 43mADC on finals.
Why the THD measured lower today than yesterday is a mystery to me.
I might swap in a biplate 2A3 and see anything changes.
I meant you should measure the distortion of just the generator.
Then measure the distortion of the amp at the grid of the output tube so you know how much of the total is attributable to something other than the output tube.
Tre'
Have Fun and Enjoy the Music
"Still Working the Problem"
I have two 2A3 spice models one based on the RCA and a Sofia.
At 43ma (1w) and 2.5K I get 2.2% for the RCA and 3.8% for the sofia.
I set the bias to 43ma and the grid to -50V for each and let the B+ fall where the model put it. (I did not make either of the models but I can trace their curves if anyone wants)
sofia 2A3
RCA 2A3
Post a Followup:
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: