|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
141.239.172.61
In Reply to: RE: What are the pros and cons? nt posted by kyle on December 08, 2016 at 11:23:15
Thank you for replying. In What kind of amp did you use the paralleled 6sn7?
Follow Ups:
Both sides of a 6SN7GT in each channel of a 300B SET power amp.
Hi Frihed, how did you use the 6sn7 in your amp? What were the parameters?
I don't know. It's an Audio Note (UK) Conqueror Silver amp. I've never asked, or looked. It could be an SRPP in front of a coupling cap.
I think it's 6SN7 DC cascade then cap coupled to the 300B. A 3 stage amp.
This was the reply I got when I posted the circuit from the schematic on the web.
"Looks like DC coupled, cascaded, common cathode 6SN7 sections.
Eli D."
.
There's a schematic of the Conqueror on the web. I'm not sure how accurate it is.
Edits: 12/09/16
I have used paralleled 6SN7s in SE 2A3 and 300B amps. The other thing, I usually load them with a CCS and LED bias them. Good power supply isolation on top and full mu combined with no cap bypass on the cathode. Heresy for some but the results sound good and you run the tube with a horizontal load line. I use two red LEDs for about -3.5V bias.
With the CCS, a 6SN7 has enough gain for a two stage amp if you use a preamp. If you're using a passive or straight out of a DAC, you should look at the voltage gain available.
So. you used a single 6sn7 to a 2A3.
Did you make your own CCS?
I mostly use a preamp so sensitivity for the input is not a big issue.
Post a Followup:
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: