Welcome! Need support, you got it. Or share you ideas and experiences.
Return to Room Acoustics Forum by Rives Audio
71.59.73.4
In Reply to: RE: Basement 2 Channel Room Build Out Dimensions - Help posted by xodeuce on June 11, 2009 at 11:11:55
If I had to do over i would....
Angle the walls like an auditorium so that the front wall is 2' shorter than the rear.
Ramp\valt the ceiling in one foot ramps.
Angle the front in two sections.
Build four subwoofers one in each corner, right into the wall.
Build panel traps into the corners of the room tuned to 80hz or so.
Wire for surround sound.
these things will eat up some space but wouldn't cost that much and flutter would be non-excistant. You would be very far ahead before you started treating.
Scott
I would just make a manifold towards the front of where your main speakers are located and make an Infinite baffle subsystem with the same 4 subs......
You would have increased efficiency, which would require a lot less amps, would only need one.... And you can get pretty low, and not have worry about localized bass
-chris
Post a Followup:
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2009, Audio Asylum, all rights reserved ]
[ Go Green ]
[ Take5 ]