Posted by PaulMC (M) on June 29, 2009 at 05:18:14

In Reply to: RE: 15A High Current UO blowing fuses after hard transient hit. posted by kenster on June 28, 2009 at 18:09:14

If the Tranzorbers die it's usually a direct short which is what it sounds like. You should send it back for repair.

• RE: 15A High Current UO blowing fuses after hard transient hit. - kenster 07:50:53 06/29/09 (2)
  In Reply to: RE: 15A High Current UO blowing fuses after hard transient hit. posted by PaulMC on June 29, 2009 at 05:18:14

  Thanks Paul. I've already purchased 6 1.5KE36CA TVSD's and will replace
  them all and go from there.
  
  I just found it odd that 5 of the 6 TVSD's were shorted with D3, which is in the middle of the series connected components, still good but I've seen stranger things in electronics.
  
  Thanks again,
  
  ~kenster
  
  
  

  ---

  • RE: 15A High Current UO blowing fuses after hard transient hit. - PaulMC 09:29:04 06/29/09 (1)
    In Reply to: RE: 15A High Current UO blowing fuses after hard transient hit. posted by kenster on June 29, 2009 at 07:50:53

    Nice. Well done!
    

    ---

    • RE: 15A High Current UO blowing fuses after hard transient hit. - kenster 11:57:02 06/29/09 (0)
      In Reply to: RE: 15A High Current UO blowing fuses after hard transient hit. posted by PaulMC on June 29, 2009 at 09:29:04

      Replaced all 6 TVSD's and we are back in business.
      
      Cheers,
      
      ~kenster
      

      ---

Post a Followup:

---

[ Follow Ups ] [ Post Followup ] Thread: [ Display  All  Email ] [ Power Forum ]
[ Comment ] [ Edit ] [ Delete ] [ Copyright Warning! Click for Details ]

---

[ Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2009, Audio Asylum, all rights reserved ] [ Go Green ] [ Take5 ]

---

[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]

---