|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
195.218.197.16
In Reply to: RE: cMP - the open source high-end Memory Player posted by gene_ on April 13, 2010 at 16:02:56
Here photos. My friend used LClock XO3 24,5760 MHz (24,5760/512=0.048 MHz) because the mode output 96 KHz is used in cPlay.
Follow Ups:
Hi Mihaylov
Just to check if GND of LClock XO3 feed cable is soldered to Pin 2 of the 10 pins header.
Regards
Hi Mihaylov !
How do you think , can I use LClock XO3 45,158 Mhz and Juli@ will support it for 176.4 output, and if yes, will it improve shape of an impulse ? My oscilloscope show good impulse shape up to 96KHz .
Picture below 176.4KHz output. Thanks, Gene.
Hi Gene!
You should use LClock XO3 22,5792 MHz for the output frequencies multiple 44.1 KHz (44.1, 88.2, 176.4) and mount it on the Juli's board instead of the oscillator Х1.
I have not understood in what place you looked the oscillogram.
The oscillogram in output LClock XO3 looks so (I checked it).
If you are going to buy LClock XO3 pay attention to remarkable possibility of its usage (see the link).
It was taken from BNC Juli@ , this pictute show 41.1 KHz. As you can see, shape of an impulse in picture difrent. Any suggestion. Thanks, Gene.
Thanks Mihaylov, one of the best explanation i have seen.
Regards, Gene.
Post a Followup:
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: