Welcome! Need support, you got it. Or share your ideas and experiences.
Return to Planar Speaker Asylum
193.11.153.133
In Reply to: RE: Can I just disconnect a bad panel in my Quads? posted by kentaja on December 15, 2016 at 05:18:10
Thank you for your prompt reply, kentaja!
I have to prepare for a solid number work hours on my work bench then, I'm sure... Do you happen to know if somebody have published a photo sequence showing a dismantling of the 63/988/989?
Per
Follow Ups:
Don't know of any on-line guides. The 98 series is a bit more difficult versus the 63.
Turn the speaker upside down and remove the bottom plate. The entire bass assembly will need to be remove. It is attached to the upper assembly with (8) M7 bolts. Remove the bolts. Unsolder the two wires soldered to the delay assembly. Unsolder the wire going to the EHT supply. Remove the sniffer antenna wire going through the delay line assembly.
Now the entire bass assembly can removed. Remove the grille.
Remove the front/rear screens. They are screwed to the frame. You can use a flat head screw driver to pry them off the frame.
Remove the dust assemblies, front/back, by using the flat head screw driving an inserting in the top slots on either side of the covers. Pry the corners loose and remove the covers. DO NOT CUT OFF.
Thank's, that will of great help!
I put this aside until I have grown enough courage to try it... In the mean time I have my new set of Quad 2912:s to listen to!
Per
Post a Followup:
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: