Welcome! Need support, you got it. Or share your ideas and experiences.
Return to Planar Speaker Asylum
71.67.188.239
In Reply to: RE: MG 1 Capacitors posted by gwestwood on October 21, 2015 at 17:40:31
What caps did you get?
Follow Ups:
I am using Clarity caps esa series.I actually have two sets of the mg-1 and recapped the first pair earlier with the same caps with good results
I am still having trouble getting the bass panel to work.I have changed the caps ,wires and hookups on both speakers One works great the other no bass .When I run a jumper wire from connection board where one side of the caps are hooked up to the other connection where the other side is hooked up I get Bass.With out the wire no bass.I'm thinking I might need to change the connection board or capacitor issue.This is the 2nd pair of mg-1 s Ive recapped I had no issues with the first pair.Any ideas or suggestions would be appreciated
Edits: 10/28/15
can you test al the segments in the entire wiring scheme to locate the disconnect or is it out of reacch? If out of reach then just disconnect the old wires and put in new wires and caps according to the schematic. Obviously your test is showing that the bass panel is functioning fine. In that test you bypassed just the cap(s) with a wire?
Post a Followup:
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: